Wednesday 24 April 2019

Hunting For NDBs In CLE243

YPM - 274 courtesy: VE3GOP



This coming weekend will see another monthly CLE challenge. This time the hunting grounds will be 270.0 - 319.9 kHz.

 





For those unfamiliar with this monthly activity, a 'CLE' is a 'Co-ordinated Listening Event', as NDB DXers around the world focus their listening time on one small slice of the NDB spectrum.

If you've been meaning to participate in  CLE, then maybe this weekend is a fine time to try!

A nice challenge in this one is to hear YPM - 274, located in northwest Ontario near Pikangikum.

'YPM' runs just 25W into a 100' vertical but is well-heard throughout North America. Listen for its upper-sideband CW identifier (with your receiver in the CW mode) on 274.368 kHz.

Summer lightning storms may provide additional listening challenges but maybe we will get lucky.

When tuning for NDBs, put your receiver in the CW mode and listen for the NDB's CW identifier, repeated every few seconds. Listen for U.S. NDB identifiers approximately 1 kHz higher or lower than the published transmitted frequency since these beacons are modulated with a 1020 Hz tone approximately.

For example, 'AA' near Fargo, ND, transmits on 365 kHz and its upper sideband CW identifier is tuned at 366.025 kHz while its lower sideband CW ident can be tuned at 363.946 kHz. Its USB tone is actually 1025 Hz while its LSB tone is 1054 Hz.

Often, one sideband will be much stronger than the other so if you don't hear the first one, try listening on the other sideband.

Canadian NDBs normally have an USB tone only, usually very close to 400 Hz. They also have a long dash (keydown) following the CW identifier.

All NDBs heard in North America will be listed in the RNA database (updated daily) while those heard in Europe may be found in the REU database. Beacons heard outside of these regions will be found in the RWW database.

From CLE organizer Brian Keyte, G3SIA, comes the details:

 Hello all

Our 243rd co-ordinated listening event is this weekend, covering a 50 kHz
frequency range - about three times wider than usual. 

    Days:     Friday 26 April - Monday 29 April
    Times:   Start and end at midday, your LOCAL time
    Range:   270.0 - 319.9 kHz  (NDB signals only)

In part of the frequency range it might be quite a challenge to tease out
the NDB signals from among the DGPS ones.
Any first-time CLE logs will be very welcome, as always.

Please log the normal NDBs you can identify that are listed in the range
(it includes 270 kHz but not 320 kHz).

Please send your CLE log to NDB List, if possible as a plain text email
and not in an attachment, with 'CLE243 FINAL' at the start of its title.

Show on EVERY line of your log:
  #   The Date  e.g. '2019-04-26', etc.  (or just '26')
  #   UTC  (the day changes at 00:00 UTC).
  #   kHz  - the beacon's nominal published frequency if you know it.
  #   The Call Ident.

Those main items can be in any order within themselves, but BEFORE any
other optional details (Location, Distance, etc.) later in the same line.

As always, give details in your log of your own location and the receiver,
aerial(s), etc. that you were using.
If you send any interim logs, be sure to send a FINAL (complete) one.

You can find anything else to help you, including CLE seeklists for your
part of the World, from the CLE page, http://www.ndblist.info/cle.htm

Please look out for our 'Any More Logs?' email at about 17:00 UTC on
Tuesday so that you can check that your CLE log has been found OK.

Do make sure that your log has arrived at the very latest by 08:00 UTC
next Wednesday, 1st May.
We are hoping to make all the combined results within a day or two.

Enjoy your listening
Brian and Joachim

-----------------------------------------------------------------
From:      Brian Keyte G3SIA      ndbcle'at'gmail.com
Location:  Surrey,  SE England    (CLE coordinator)
-----------------------------------------------------------------

(Reminder:  You could use any one remote receiver for your loggings,
stating its location and owner - with their permission if required.
A remote listener may NOT also use another receiver, whether local
or remote, to obtain further loggings for the same CLE).

These listening events serve several purposes. They:
  • determine, worldwide, which beacons are actually in service and on-the-air so the online database can be kept up-to-date
  • determine, worldwide, which beacons are out-of-service or have gone silent since the last CLE covering this range
  • will indicate the state of propagation conditions at the various participant locations
  • will give you an indication of how well your LF/MF receiving system is working
  • give participants a fun yet challenging activity to keep their listening skills honed

The NDB List Group is a great place to learn more about the 'Art of NDB DXing' or to meet other listeners in your region. There is a lot of good information available there and new members are always very welcome. As well, you can follow the results of other CLE participants from night to night as propagation is always an active topic of discussion.

You need not be an NDB List member to participate in the CLEs and all reports, no matter how small, are of much value to the organizers. 

Remember - 'First-time' logs are always VERY welcome!

Reports may be sent to the NDB List Group or e-mailed to CLE co-ordinator, Brian Keyte (G3SIA), whose address appears above. If you are a member of the group, all final results will also be e-mailed and posted there.

Please ... give the CLE a try ... then let us know what NDB's can be heard from your location! Your report can then be added to the worldwide database to help keep it up-to-date.

Have fun and good hunting!

No comments: